Whether the new hinge needs to be adjusted after installation

New hinges usually need to be adjusted after installation to ensure that the door panel or cabinet door can be opened and closed smoothly and tightly, and maintain a good alignment with the cabinet or door frame. Here are the main reasons and steps for adjusting hinge position:

The main reason for the adjustment

Installation error: During installation, the position of the hinge may be deviated due to manual operation or measurement error.

Small deformation of the door panel or cabinet: The door panel or cabinet may appear small deformation after a long time of use, resulting in the hinge position is no longer accurate.

Make sure the switch is smooth: By adjusting the hinge position, you can ensure that the door panel or cabinet door will not be stuck, abnormal noise or shaking when opening and closing.

Steps of adjustment

Observe the current situation: After installing the new hinge, first observe the opening and closing of the door panel or cabinet door, and pay attention to whether there are problems such as stuck, abnormal noise or shaking.

Determine the direction of adjustment: Based on the observation results, determine the direction of adjustment of the hinge. For example, if the door panel or cabinet door slopes up or down, it may be necessary to adjust the height of the hinge; If there is a gap between the door panel or cabinet door and the cabinet or door frame, the left and right positions of the hinges may need to be adjusted.

Loosen the screws: Use a screwdriver to loosen the hinge screws that need to be adjusted, but do not completely remove them.

Fine-tuning: Gently move the hinge into place, then test by holding the door panel or cabinet door. Adjust the hinge position gradually as needed until the door panel or cabinet door can be opened and closed smoothly and tightly, and maintain a good alignment with the cabinet or door frame.

Fixing screws: After adjusting the hinge position, tighten the screws with a screwdriver. Be careful not to over-tighten, so as not to damage the hinge or screw.

Matters needing attention

Safety first: When adjusting hinge position, be careful to avoid being cut by screws or hinges.

Meticulous patience: Adjusting the hinge position requires meticulous patience, do not rush. Adjust gradually and test several times to ensure the best results.

Refer to installation instructions: If you are not sure how to adjust the hinge position, you can refer to the installation instructions of the hinge or consult a professional.

In short, after the installation of new hinges, it is usually necessary to adjust the position to ensure that the door panel or cabinet door can be used normally and remain beautiful.